FTW Flat Rib Washer for Wood Batters 105MM (H) x 50MM (W) x ~3MM (T)

Description

The Form Tie system prevents breakage in the formwork, thus keeping concrete structures in good shape without discolouration. Besides ease of assembly and removal, the system saves construction costs as all parts are reusable except for the separator, which is casted into the wall. 

Form Tie Complete Set Requirements 

		Parts	Quantity
		Form Tie with a Nut	2 pcs
		Inner Unit B	1
		Plastic Cone	2
		Flat Rib Washer	2

Inner Unit 

Inner units of all sizes can be made and supplied upon request depending on required wall thickness. 

Type	Dimensional Diagrams
Inner Unit B

Plastic Cone (Type B-Plywood Panel) 

	Diagram	Remarks
		A- Panel thickness  B- Inner unit diameter

Washer 

Diagram	Remarks
	Flat Rib Washers For Wood Batters

Accessories 

Rubber Ring	U Clip	Form Tie Spanner	Box Spanner D and B

Assembly 

Plastic cone to be attached to both ends of Inner Unit..  Drill a 12mm hole for the passage of a plastic cone axis at a prescribed location in the panel before hand..  Insert the Inner Unit from the inner panel and screw on the Form Tie..  Erect the studs successively. Apply the Flat Rib Washer to the wales and tighten with nuts..  Repeat the same procedure for the outer panel..

Disassembly 

Loosen nut and remove the wales..  Remove Form Tie..  Take off panel..  Remove plastic cone from concrete surface. Plastic cone hole is filled up by cement mortar..

Disclaimer
All product images shown are for illustration purposes only. Actual products may varies in term of size, type, brand, version, colour, and other relevant characteristics.