CMI 181 Grey Tilefix High Quality Polymer Modified Cement Based 25KG

Description 

CMI TILEFIX GREY 181 is a high quality polymer modified water—resistant cement-based adhesive for use in fixing of ceramic wall and floor tiles. It is suitable for interior and exterior use in thin or medium bed applications ( 3 mm to 6 mm ). 

Advantages 

• Consistent Quality. 
• Minimizes Cracks. 
• User Friendly. 
• Water Resistant. 
• Enhanced Workability. 
• Cost Effective. 
• Optimum Bond Strength. 
• Cleaner Worksite. 

Technical Data 

Application Procedure 

The substrate should be sound and free from grease, paint and other contaminants. Mix CMI TILEFIX GREY 181 into approximately 6 liters of clean water until a slump free consistency is attained. Allow mixture to stand for 10 minutes before mixing again. For fixing of exterior tiles, CMI MORTAR ADMIX 380 is recommended to replace water. Spread mixture with a notched – trowel onto substrates or by buttering backface of tile. For heavier tiles or tiles with high grooves or ridges, combination of both is recommended. Do not spread adhesive more than 1 m.sq. at a time and ensure that tiles should be fixed immediately or within 10 minutes. The tiles should be firmly pressed onto sub—base and immediately knocked into position. In case of long delay, remove the existing adhesive and comb out a fresh layer. Ensure that backface of the tile is in good contact with the adhesive for best results. 

*Important : Tiles must not be soaked in water. 

Storage 

Storage life is approximately 6 months if stored in a cool and dry place