AD Plas AD 013 Plaster Contact Layer 20KG

Building Materials/Cementitious Products

AD Plas AD 013 Plaster Contact Layer 20KG 

Properties and Application 

• AD 013 is a plastic dispersion mixed with quartz sand and is characterised by itss good alkali resistance. It is used as a bonding layer for mineral plasters on smooth, membrane type substrates. AD 013 is suitable as a bond improving sub-coats for plasters based on gypsum, lime and cement. Its application is particularly recommended on problematic substrates liike very dense and smooth concrete components, highly absorbent materials such as foam mortar, etc. Its application is particularly recommended on problematic substrates like very dense and smooth conctrete components, highly absorbent materials such as foam mortar, etc. and for dry plasters. AD 013 reduces the absorbency of mineral substrates and therefore prevents the plaster applied from burning caused by high rapid water removal.. 

Advantages 

• Ready-to-use. 
• Solvent-free. 
• Improves bonding. 
• Strengthen substrates. 
• Easy application; can be sprayed, rolled or painted. 
• Minimize sagging during application. 
• Can be over-coated as early as after 24 hours. 
• For smooth and highly absorbent substrates. 

Surface Preparation 

The substrate must be clean, frost-free and load bearing, free from grease, paint, separating agents and loose particles. Brittle, soft or weakly bonded substrate components must be removed. 

Application 

AD 013 can be applied by spraying, painting and rolling. It is ready to use and should only be modified by the addition of 10% to spraying consistency for mechanical working. Before use, any settled quartz sand should be mixed in stirring. Plaster should only be applied once the coating is fully dry. Check dryness with a scratch test before covering. AD 013 cannot be worked at substrate temperatures below +5°C. 

General Remarks 

All times specified are based on +23°C and 50% relative humidity. Higher temperatures and lower humidity increase, low temperatures and higher humidity decrease working time and drying time. 

Technical Data 

Packing And Storage 

• Packing : 20kg plastic bucket. 
• Shelf-life: 12 months minimum in sealed original container. 
• Storage: Keep in frost-free, cool and dry condition. 

NOTE: The consumption specified is a calculated estimation. Due to diverse nature of substrates and site conditions, actual coverage of may vary. 

Remarks: The information given in this data sheet is to the best of our knowledge true and accurate ; but we have no control over where or how the product is applied, there are no warraties expressed or implied regarding the product's use or perfomance, customers are advised to thoroughly test them adapting them to their own use. 

Disclaimer
All product images shown are for illustration purposes only. Actual products may varies in term of size, type, brand, version, colour, and other relevant characteristics.