V-Tech VT-230 Vital Nails Construction Adhesive Sealant 350GM

Description
• VT-230 Vital Nails is a one-component construction adhesive sealant formulated to bond on a variety of common construction materials.
• It has strong initial grab, superior adhesion, and does not slump on vertical surfaces.

Features
• SVHC compliant
• Mirror and polystyrene
• Strong initial grab
• Non-drip paste
• Excellent adhesion on most substrates
• Can be extruded even in low temperatures

Specification
• Base: Synthetic rubber
• Physical State: Thick paste
• Colour: Brown
• Open Time: Max. 5 minutes (at 25 °C & 50% R.H.)
• Curing Time: 24 – 72 hours
• Packaging: 350 g/cartridge (24 cartridges/carton)
• Shelf Life: 18 months (cartridge)
• Storage: Store in a dry and cool place with temperature around 30 °C
• Application Temperature: -20 °C – 38 °C
• Service Temperature: -30 °C – 60 °C

• Curing system: Solvent evaporation
• DATA Specific gravity: 1.20 g/mL
• Lap shear strength: 3.2 N/mm² ASTM D1002 (Wood-to-wood)
• Solid content: 77 %
• Freeze/Thaw stability: 5 cycles

Applications
• Ideal for bonding most construction materials: wood, particle board, metal, concrete, fibrereinforced cement board, ceramics, bricks, flooring panels.
• Can be used on polystyrene and mirror.

Application Direction
1. Surfaces must be clean, dry and free of dirt, grease, oil or water.
2. For a neat finish, apply masking tape and remove it before construction adhesive skins over.
3. Cut tip off and puncture the internal foil seal with nozzle. Cut nozzle at 45° angle to desired bead-width and apply to substrate with cartridge gun.
4. Two-way contact (Lighter substrate bonding): Apply adhesive onto substrate to be bonded, press firmly, and pull apart. Allow to tack-off for 10 to 30 seconds and press firmly together again. Contact areas should be tapped with a rubber mallet to ensure intimate contact.
5. One-way method (Heavier substrate bonding): Apply adhesive onto substrate to be bonded, press firmly, and securely fasten them together (clamp, nail, screw, etc.). Retain fastening for a minimum of 24 hours.
6. Any wet or partially wet adhesive can be removed with a piece of cloth. Dried adhesive is best removed with scraper or by sanding.

Caution
• Contains AMIDE WAX.
• May produce an allergic reaction.
• Highly flammable liquid and vapour.
• Causes skin irritation.
• May cause drowsiness or dizziness.
• Suspected of damaging fertility or the unborn child.
• May cause damage to organs through prolonged or repeated exposure.
• Toxic to aquatic life with long lasting effects.
• If medical advice is needed, have product container or label at hand.
• Keep out of reach of children.
• Keep away from heat, hot surfaces, sparks, open flames and other ignition sources.
• No smoking. Use only outdoors or in a wellventilated area.
• Wear protective gloves/protective clothing / eye protection/face protection / hearing protection. Collect spillage.