Qinglong Everywhere In One Waterproof Coating 1KG

Features

• When used, mix pre-polymer A and water curing agent B in a ratio of 1:0.2. It is a cured product that can be applied on damp surfaces.
• 100% environmental-friendly, non-toxic and odorless after curing, non-polluting especially suitable for waterproofing of drinking water projects and children’s facilities.
• High tensile strength, good ductility, and excellent adhesion. 
• Resistant to heat, cold, chemical erosion, and aging. It can prevent mold effectively and retard fire.
• Ease of use, labor-saving, time-saving, cost-saving, and safety.

Product Specifications

• Size: 1kg
• Colour: Blue

Application Range

• Especially suitable for waterproofing drinking water reservoirs and places with special environmental protection requirements, and it complies with VOC limit value.
• Roof, kitchen and bathroom, basement, exterior wall, floor, gutter, balcony, planter, swimming pool, cold store and etc.
• Repair of cracks in buildings, and sealing of expansion joints.
• Protect various pipes against corrosion.

Application Methods

1. Surface preparation: the surface must be firm, clean, and free of dust, oil, sand, and water.  Defects such as cracks should be repaired first, and internal and external corners to be made round;
2. Stir the coating in the container thoroughly before use to prevent precipitation. Mix A and B using a ratio of 1:0.2 and apply the coating with a brush or scraper.
3. The coating can be set in one application on a horizontal surface. In order to prevent dripping, apply a very thin coat on a vertical surface. After approximately 5-10 minutes (depending on the temperature of the site and the environment) the mixture is left in the container, apply another coat on the first layer based on the required thickness for the design. On that, the thickness required for the design is once applied to the base layer; it should be after 24 hours (when the first layer is non-sticky to feet). Walking on it is not allowed when it is not fully cured;
4. Use 1:2.5 cement mortar with a thickness of 20mm or other materials as the protective layer, or expose it without a protective layer, the color of the paint will change;
5. Recommended consumption: 1.5kg/㎡~2.0kg/㎡ (thickness 1.2mm~1.8mm).